Calculated Industries 6025 User Manual
Page 6
[RESET] – Hardware Reset
If
your
Scale Master Pro should ever “lock
up,” use a paperclip or similar size object
to press the RESET hole. Clears all values,
including memory. All permanent settings,
including Preferences, remain intact.
[SET] – Set Key
Used with other keys to access second
functions and place the Scale Master Pro into
programming mode. If in programming
mode already, pressing
[SET]
will store
the displayed value and exit programming
mode. A press of
[SET]
after rolling locks
the measurement. While locked, the
displayed value will not be affected by
rolling the Scale Master Pro. A second press
of
[SET]
will unlock the measurement.
[RCL] – Recall Key
Used to recall stored values. When you
press
[RCL] [RCL]
, the last value rolled
is displayed, allowing roll to continue
from this value. Recalling any other value
disables measuring until the recalled value
is cleared with a press of
[ON/CLEAR]
.
[IMP/MET] – Imperial/Metric Switch
Toggles between Imperial and Metric
modes.
User’s Guide – 2