Calculated Industries 6025 - Manual (Page 25)

Setting a Height
The height function is used to enter a height
value for finding volume.
To set a height:
1) Press
[SET] [LxW] to access the height
function. The appropriate annunciator
will begin flashing “
FT IN ” for Imperial
mode or “ M ” for Metric mode. An “ H ”
will appear in the display.
2) To change the units of measurement,
press [UNITS] until your desired units
appear. Press the [M+] ( X ) or the [LxW]
( W ) key to begin setting the distance.
The selected digit will start flashing.
3) Press [COUNT] ( S ) to increase or [RCL]
( T ) to decrease the selected digit. Press
the [M+] ( X ) key to move to the next
digit to the right or the [LxW] ( W ) key to
move back to the left.
4) Once the desired value has been entered,
press the [SET] key to save and exit.
21 – Scale Master
®
Pro