Calculated Industries 6020 v3.1 - Manual (Page 5)

3 – User’s Guide
a height has been stored. Please see page 12 for
calculating an Area and Volume.
[RESET]
Used to clear the display. When pressed together
with another key, clears the value of that key.
Imperial/Metric Modes
The Scale Master Classic is set up to use Imperial
(Standard) scales by default. The Scale Master
Classic can be set up to use Metric mode by
performing the following steps:
1) All Clear by pressing [RESET] and
[SUBTRACT/COUnT] simultaneously. " ALL
CLEARED " should display for 1 second.
2) Press and hold [RESET] , then press [MODE]
twice.
3) Release the [RESET] key.
While in Metric mode, MET will remain lit in
the display.
Repeat the steps above to switch back to
Imperial mode.
U
sinG The
s
Cale
M
asTer
C
lassiC
Adjusting the Wheel
The Celcon® polymer
wheel can be adjusted for
each user’s preference. To
adjust the wheel, take a
small, flat-head jeweler’s screwdriver and slightly
rotate the screw located near the wheel tip.
Rotating the screw about 1/4 to 1/3 turn should
Rotate to Adjust Wheel
(Cont’d)