Calculated Industries 9530 User Guide - Manual (Page 7)

User’s Guide — 3
N – Next Employee
Prepares the Time Card Tabulator II for
acceptance of new employee data.
e – Employee Hours Key
A multifunction key used to display
the following:
1) Accumulated “In” and “Out” hours
2) Total employee hours
3) Gross employee pay (based on
stored rate of pay).
4) Also used to directly enter the total
hours for a day.
π – Payroll Total Hours
Sums and displays the total hours
worked by all employees. This total
is cleared when the calculator is
turned off or reset.
R – Rate
Multiplies a numerical or time value by
the rate or temporarily overrides a
stored rate.
Note: When entering a math string, R
pressed after a unitless value will override
the previous rate. For example, if you enter
2 • 5 H x 1 0 R , 10 is used as
rate instead of stored value.
s R – Store Rate
Permanently stores a unitless value
as a rate. You may clear the value by
performing a “Clear All” (
C x ) or
replace it with another value.