Bully Dog 44633 VW TDI Rapid Power Module - Manual (Page 6)

5
1.Make sure vehicle’s engine is off.
2.Remove the vehicle engine cover to gain
access to the Fuel Rail Pressure sensor. To
remove the engine cover gently but firmly
pull upward on the front of the engine cover.
The engine cover will remove very easily so if
it seams difficult try pulling it upward from a
different location to avoid breaking the grom-
mets that hold the engine cover in place.
3. Once the engine cover is removed locate the fuel rail pressure sensor plug, the sensor plug
is on the passenger side of the engine and is connected to the end of the common fuel rail.
4. Disconnect the pressure sensor plug from the common rail. The release mechanism for
the plug is located on the bottom side of the plug; a tool may be neccessary to gain enough
leverage to disconnect the plug. To understand how the release mechanism works look at
the module female plug, it is identical to the pressure sensor plug.
Common fuel Rail
Pressure sensor plug
Installation