Bully Dog 81201 Rapid Flow - Manual (Page 7)

6
6
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81010,81201
2. Place all of the supplied Hangers into their ap-
propriate locations as shown in the diagram.
3. Install the Down Pipe. You will use the stock band
clamp to secure the Down Pipe to the turbo. Se-
cure the Down Pipe by tightening the stock band
clamp with a 7/16” deep socket.
4. Hang the Intermediate Pipe from Hanger A and
secure the Down Pip using one of the supplied
clamps. At this point, secure the connection so
that the piece will stay, but do not tighten down
until the entire exhaust is installed.
5. At this point, you will skip installing the Straight
Pipe and Muffler and continue working towards
the rear of the vehicle.
Down Pipe
Clamp
Intermediate Pipe
Turbo
Exhaust Band Clamp
Hang the Hangers
Tighten Stock Band Calmps
Install Downpipe
Reinstall Catalytic Converter
7/16”