Bully Dog 81410 Rapid Flow User Manual

Page 7

rAPid FlOW inSTAllATiOn

rapid Flow exhaust # 81410

2. Place all of the supplied Hangers into their

appropriate locations as shown in the above

diagram. There is a hanger on the Catalytic

converter that will be reused .

3. In order to fit the new Down Pipe into the engine

bay, the firewall seam might need to be bent

or trimmed in order to provide the necessary

clearance. If you use either an adjustable wrench or

vise grips to grip the seam lip as far as possible and

bend the lip out of the way. Make sure your Down

Pipe is not rubbing on anything that will cause

noise or friction on any part.

4. Install the Down Pipe by sliding it up from

underneath the truck. You will use the stock band

clamp to secure the Down Pipe to the turbo. Secure

the Down Pipe by tightening the stock band clamp

with a 7/16” deep socket.

5. Install the Second Piece Down Pipe to the Down

Pipe using one of the supplied clamps. At this point

secure the connection, but don’t tighten down the

clamp until the entire exhaust is installed.

Hang the Hangers

Fire Wall Adjustment Area

7/16”

Stock Band Clamp

Down Pipe

Install Down Pipe

Install Second Piece Down Pipe