Bully Dog 81444 Rapid Flow - Manual (Page 5)

6
6
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81444
1.Use a sawzall to cut the exhaust
immediately behind the muffler.
2.Then cut the exhaust 4 inches behind the catalytic
converter in front of the band clamp.
3.Next unbolt the front of the Catalytic Converter.
4.Then make a cut at the bottom of the down pipe.
5.Use a 7/16” deep socket to
loosen the stock band clamp at
the top of the stock down pipe.
The stock band clamp will be
reused, so you will not need to
completely remove it.
6.Remove each piece of the stock exhaust system,
including the stock hangers. To make removing
the Hangers easier, it is rec-
ommended that you use a
silicone spray on each of the
rubber hangers that hold the
stock exhaust.
ImPoRTaNT: It is illegal in all 50 states to remove the catalytic converter.
#2 Cut Exhaust in front of band clamp
#4 Remove necessary exhaust hangers
#1 Cut Exhaust after muffler
REMOVAL OF STOCk EXHAUST SySTEM
In these steps you will remove the stock exhaust system.