Bully Dog 83040 Rapid Flow - Manual (Page 5)

4
4
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 83040
REMOVAL OF STOCk EXHAUST SySTEM
In these steps you will remove the stock exhaust system.
Important: It is illegal in all 50 states and Canada to remove the
catalytic converter.
1. Undo the four bolts on the flange behind the Catalytic
converter. If you system does not have a flange , cut the
exhaust system starting after the catalytic converter. On
some vehicles you will need to cut 1 inch in front of the
band clamp. Both ways are pictured.
2. Use a sawzall to cut the exhaust immediately behind the
muffler.
3. To make removing the Hangers an easier
process, it is recommended that you use a
silicone spray lubricant to spray each of the
rubber hangers holding the stock exhaust.
4. Remove each piece of the stock exhaust system, including
the stock exhaust hangers.
Undo Bolts & Flange
or Cut Exhaust 1” before Band Clamp
Cut Exhaust after muffler
Remove Hangers Exhaust Removed