Bully Dog 84010 Rapid Flow Exhaust System - Manual (Page 8)

7
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 84010
2. Begin the installation with the driver side 1 pipe by attaching it to the drivers side catalytic converter. Make
sure that the stock gasket is in place before attaching this exhaust piece. Use the stock hardware to secure
the tube.
3. Attach passenger side 1 tube making sure to reinstall the gasket. Use the stock hardware to secure the tube.
Now move to the tail section of the exhaust to install the tail pipe and axel piece.
4. Locate the grommet location for the tail pipe
and place the tail pipe hanger into the grom-
met to hang the tail pipe. Hold the tail pipe in
place and get ready to place the axle piece.
5. Install axle piece 1, use the axle piece grommet
location to insert the hanger that is welded
onto the axle piece and then insert the other
side of the axle piece into the tail pipe. Use a
clamp to loosely secure the joint between the
axle piece and the tail pipe.
Install Driver Side 1 and Passenger Side 1
Grommet location
Tail Pipe
Hang the Tail Pipe
Hang the Axle Piece
Axle 1
Tail Pipe
Axle 1 grommet