Bully Dog 4110x Bully Dog 4 Position Chip - Manual (Page 7)

6
Installation
• This is a close-up of the switch set top position “0”
2. Once you have properly mounted the chip, secure the chip
to the computer with 2” wide package sealing or duct
tape.
Stage 6: Re-installing Computer
1. Return the computer to its original location.
• Be sure the box holding the computer in place does not bind the
chip and cause it to tilt.
2. Re-connect the wire harness.
3. Test the vehicle by starting the engine.
4. If it starts ok, secure the computer to the metal bracket
with the original bolt or by using tie wraps.
5. Install the switch in a convenient location, such as a glove
box.
6. Secure the wires with zip ties.
7. Reconnect the negative battery wire.