Bully Dog 151000 Ford 7.3L Power Stroke w/ auto trans E40D & R4100 - Manual (Page 6)

5
Modifications
3. Replace the shift plug and retaining clip and use the same procedure on the other two shift plugs located on
the valve body.
4. To remove the actuator, simply press in on the actuator face to relieve tension and then remove the retaining
clip that holds the actuator in place.
5. Replace the existing actuator with the new Bully Dog actuator. Make sure the new O-Ring is in place on the
actuator. Put the new actuator in the valve body and place the retaining clip back in place to hold the new part.
9. The valve body is now ready to be placed back in the truck. Clean the valve body thoroughly, place the valve
body back in the truck and tighten the bolts to 8-10 ft-lb of torque. Do the same with the 2 nuts.
10. Replace the pan and all the bolts and refill the transmission with Bully Dog Technologies Rapid Power ATF.
Check for leaks and enjoy the power.
O-RING