BSA Optics HMRGBD30CP - Manual (Page 13)

13
DO NOT attempt to disassemble or clean the sight internally. This will invalidate the
warranty.
If the scope requires repairs or adjustment, complete instructions can be
found in the warranty.
The external optical surfaces should occasionally be wiped clean with the lens cloth
provided, a soft lint-free cloth, or an optical quality lens paper. Keep the protective
lens covers in place when the scope is not in use. Remove any external dirt or sand
with a soft brush to avoid scratching the finish. Wipe the scope with a damp cloth,
following with a dry cloth. Store the unit in a moisture-free environment.
TROUBLE SHOOTING TIPS:
Inaccuracy Issues
• First check your mount. Using your bare hands only, softly twist the sight in the
rings, check for any movement. If there is any movement, re-tighten the mount.
Non-permanent thread lock tight is recommended.
• Use a bench rest or sandbag to support the forearm and butt stock when making
windage and elevation adjustments. This will help eliminate movement.
• Always follow through with every shot.
• Always use the ammunition of the same bullet type and weight.
• Check that your rifle is properly bedded in the stock. A loose stock can create
changes to the point of impact.
• Check that your barrel and chamber are clean. Damaged rifling or excessive
grease can cause inaccuracy.
• Always make adjustments in small increments.
7. MAINTAINING YOUR ILLUMINATED SIGHT
RED DOTS UNIV MANUAL06.indd 13 2/11/09 4:05:56 PM