BSA Optics HMRGBD30CP - Manual (Page 12)

12
Zeroing The Sight Manually:
If you have a bolt action rifle: Open the action of the firearm and remove the bolt.
Looking through the bore of the rifle, make sure that the center of the target is in the
center of your view.
To pre-zero the sight,
adjust the windage and elevation screws so that the image
appearing at the center of your bore is the same centered in the riflescope reticle.
If the firearm you own is not a bolt action, we recommend the use of an optical
collimator.
CAUTION: BE CERTAIN THAT THE GUN IS NOT LOADED, THE
ACTION IS OPEN, AND THE MUZZLE IS POINTED IN A SAFE DIRECTION.
SAFE GUN HANDLING PROCEDURES MUST BE USED AT ALL TIMES.
How To Replace The Battery:
With a coin or screwdriver, unscrew the battery cap. Place the battery with the
positive side up (+ symbol), then replace the cap in the housing firmly to make sure
that it is water-tight.
Duracell model DL2032, Sunrise model CR2032, Energizer model ECR2032.
Turn the switch on, turn the switch knob clockwise to increase the intensity of the
reticle brightness, and counterclockwise to decrease it.
6. BATTERY REPLACEMENT
RED DOTS UNIV MANUAL06.indd 12 2/11/09 4:05:56 PM