BSA Optics BOW30 Dot User Manual
Page 8
8
1f) Loosen the hex head mounting bolts slightly and slide the
mounting plate up or down until the center of the red dot sight is
about where your most often used sight pin was.
1g) When finished with assembly, double check all screws for
tightness.
Tech Tip #4: Every red dot sight has internal windage and elevation
adjustment of about 15 inches at 25 yards. However, it is best to
make all the big adjustments of windage with the spacers (see pg.
2) and elevation [sliding mounting plate up or down] before making
fine adjustments with the internal click adjustments.
CAUTION: REFER TO YOUR BOW OWNER’S MANUAL
FOR PROPER USE. ALWAYS USE APPROPRIATE CAUTION
WHEN SHOOTING.
2a) Rough Sighting In. Hold your bow up at arm’s length and
familiarize yourself with the appearance of the reticle against the
target. If necessary, loosen the tow knobs attaching the rail or rings
to the mounting plate and rotate the back of the red dot sight up or
down until a full, round view through the devise is obtained. You
will note that the windage and elevation will be located at nine and
2. SIGHTING IN