Bose SL2 - Manual (Page 8)

8
Y OUR SL2 WIRELESS SURROUND LINK
English Deutsch Français Dansk Español Italiano Svenska Nederlands
To adapt the surround speaker cable for Jewel Cube ® speakers
Follow these steps before you connect the provided surround speaker cable to your Jewel
Cube
® speakers.
1. Loosen the screws on the Jewel Cube ® speaker adapter so you can insert the two-wire
ends into its terminals.
• Insert the plain wire ( –) into the plain terminal.
• Insert the red-banded wire (+) into the red terminal.
2. Tighten the screws (Figure 6).
Figure 6
Using the adapter
with a Jewel Cube
speaker
Red terminal
screw
Red band
Jewel Cube
speaker
Adapter
on wire
Using this cable with the adapters attached, follow the steps in “To make the receiver
connections” on page 7. Be sure to match each adapter to the proper speaker, right or left.
What the Status LEDs indicate
On the rear of the SL2 transmitter and receiver, the color of the Status LED indicates how
each unit is functioning. With the power pack plugged in, the LED lights as follows:
• Blinking green: when one unit is trying to link to the other.
• Solid orange: in sleep mode for low power use when there is no audio signal to
communicate.
• Solid green: the receiver and transmitter are communicating with each other.
This green LED stays lit for several minutes after communications cease.
• Blinking red: the SL2 receiver is too hot, or there is a problem with the surround speaker
cable connection between the SL2 receiver and the speakers.
For information on how to deal with a blinking red LED, see “Troubleshooting” on page 9.
02_Introduction.fm Page 8 Monday, August 7, 2006 9:53 AM