Bonide Systemic Insect Spray RTS - Manual (Page 9)

APPLICATION INSTRUCTIONS
Treat for grubs from the beginning of May to the end of October, or when first noticed. For grub
(larvae) control, ½ inch of rainfall or irrigations should occur within 24 hours after application.
Thoroughly wet the lawn a few hours after application. For armyworm and cutworm control,
do not irrigate treated areas within 24 hours after application of this product. Contact your
State Agricultural Extension Service agents for additional recommendations for your area.
RESTRICTIONS FOR LAWNS:
• Do not water lawn within one hour after applying.
• Do not apply this product to waterlogged areas.
• Do not mow treated lawn until after adequate rainfall or irrigation has occurred.
• Do not exceed one application of this product per season for lawns.
• Do not allow people and pets to re-enter the treated area until after the spray has dried.
• Do not allow this product to contact plants in bloom if bees are foraging in the treatment area.
• Do not apply more than 9.4 oz. of Imidacloprid per 1,000 sq. ft. per year.
READY-TO-SPRAY INSTRUCTIONS - LAWNS
This product is a ready-to-spray formulation. Attach the bottle to your garden hose
according to the directions below. Water will mix with this product as you spray.
1. Measure area to be sprayed. Calculate “square feet” by multiplying length times
width. This 32 fl. oz. container will cover up to 5,333 sq. ft.
2. Make sure sprayer knob control lever is in “OFF” position, then connect sprayer to garden hose.
3. When spraying turf and other low foliage, twist sprayer hood to the "FAN" position
for more uniform coverage.
4. Turn water on at faucet. To begin spraying, turn knob control lever to "ON" position.
The product mixes automatically with the water as you spray.
5. To stop spraying, turn knob control lever to the "OFF" position. Turn off water at the
faucet. To relieve pressure, turn knob control lever to the "ON" position and point the
sprayer away from any desirable plants before disconnecting the spray nozzle from
the garden hose.
Spray evenly over the measured area. 32 fl. oz. covers approximately 5,333 sq. ft. For
heavier infestations, use 32 fl. oz. to treat 3,560 sq. ft.