Bonide Grass Beater - Manual (Page 48)

improper application methods, a resistant biotype
may be present. Consult your local representative
or agricultural advisor for assistance.
Irrigation
In irrigated areas, it may be necessary to irrigate
before treatment to ensure active weed growth.
Coverage
Apply this product uniformly and completely to the
foliage of grasses on a spray-to-wet basis. Dense
leaf canopies shelter smaller grassy weeds and
can prevent adequate spray coverage. DO NOT
spray to the point of runoff.
Application Instructions
Applications (broadcast, band, or spot spray)
can be made to actively growing grassy weeds
at the rates and growth stages listed in Table
6 and Table 7, unless instructed differently in
Crop-specific Information. The most effective
control will result from making postemergence
applications of this product early, when grassy
weeds are small. Delaying application permits
grassy weeds to exceed the maximum size stated
and will prevent adequate control.
DO NOT apply when conditions favor drift from
target area or when wind speed is greater than
10 mph.
Ground Application (Broadcast)
Water volume. Use 1 to 10 pints of spray solution
per 1,000 sq. ft.
Spray Pressure. Use 30 to 60 psi (measured at the
boom, not at the pump or in the line). When crop and
grass weed foliage is dense, use a minimum of 3.67
pints per 1,000 sq. ft. of water and 60 psi.
Application Equipment. Use standard high-
pressure pesticide flat fan or hollow cone
nozzles spaced up to 20 inches apart. DO NOT
use flood, whirl chamber, or controlled droplet