Blomberg GSN 9423 A - Manual (Page 30)

29 EN
machine will fulfill the necessary
operations required to cancel the
programme. Once the Time Delay
function is cancelled, "00:00" will
appear on the Remaining Time
indicator.
C
You can select and operate a
new programme following the
cancellation of the programme.
C
There might be residues of
detergent or rinse aid left in the
machine and/or on the pieces
being washed depending on the
step the previous programme was
in at the time of such cancellation.
Salt indicator
Check the Salt indicator on the display
to see whether there is enough
softening salt in your machine or not.
You need to refill the salt container
whenever the Salt indicator lights.
C
If the water hardness level is saved
as (r1), Salt indicator will never
come on even if the salt container
is empty. (Adjusting the water
hardness level is explained in
Water Softening System section.)
Rinse Aid indicator
Check the Rinse Aid indicator on the
display to see whether there is enough
softening rinse aid in your machine
or not. You must refill the rinse aid
container when the Rinse Aid indicator
comes on.
C
If the Rinse Aid indicator is set
to OFF, Rinse Aid indicator will
never come on even if the rinse aid
container is empty.
Setting the Rinse Aid indicator
1. Turn on your machine by pressing
On / Off key while pressing and
holding the Half Load ( ) key
when the machine is in off position.
Keep holding the keys pressed in
this stage.
2. Release On / Off (1) key while
pressing and holding the Half Load
( ) key.
3. Keep the Half Load ( ) key
pressed for three seconds more.
4. Rinse Aid indicator lights up and
the Rinse Aid indicator status
saved on your machine appears on
the display as "ON” or “OFF”.
5. You can change the status of the
indicator as “ON” or “OFF” by
pressing the Start / Pause / Cancel
key.
C
If you switch off the machine with
“On/Off" key when the status is
"ON", then the Rinse Aid indicator
will come on when the rinse aid
level in your machine becomes low
while the machine is in use. If you
switch off the machine by pressing
On/Off key when the status is set
to OFF, then the Rinse Aid indicator
will never come on.
End of programme
End of Programme indicator will light
up once the washing programme
is over.
1. Press On / Off key to turn off your
machine.
2. Close the tap.
3. Unplug the machine from the
socket.
C
Leave your dishes in the machine
for about 15 minutes to cool down
after they are washed. Your dishes
will dry in a shorter time if you
leave the door of your machine ajar
during this period. This process will
increase the drying effectiveness of
your machine.