Blizzard Lighting Kontrol 5(Rev. B) - Manual (Page 14)

KONTROL 5 Manual Rev B.
Page 14
© 2012-13 Blizzard Lighting, LLC.
ALL RIGHTS RESERVED
3.6 USB Functions
KONTROL 5 is capable of saving/loading scene and chase data from USB
drives, using the USB jack on the unit’s front panel. During USB operation,
KONTROL 5’s LED display will show the following information, depending on
mode.
LED Display Means...
SAvE
Indicates KONTROL 5 is currently in Data Backup/Save Mode.
LoAd
Indicates KONTROL 5 is currently in Data Load Mode.
UP--
Indicates KONTROL 5 is currently in Firmware Update Mode.
Ft01-Ft16
Displays the current file number to be written/loaded
ot
“OK,” indicates that the current file operation was successful.
FAIL
Indicates that the current file operation was unsuccessful. Try a different USB
device or program.
3.6.1 Data Backup
Allows the user to save scene and chase data to a USB Flash “Thumbdrive.”
1. Press and hold the & buttons to enter Data
Backup Mode.
2. Kontrol 5’s LED display will show “
SAvE
.”
3. Use the buttons to select the file
name, “FILE1 - FILE16.”
4. Once backup is complete, KONTROL 5 will display the “OK” message
(
ot
) as indicated above
3.6.2 Data Load
Allows the user to load scene and chase data from a USB Flash “Thumb-
drive.”
1. Press and hold the & buttons to Enter
Data Load Mode.
2. Kontrol 5’s LED display will show “
LoAd
.”
3. Use the buttons to select the file
name, “FILE1 - FILE16.”
4. Once data load is complete, KONTROL 5 will display the “OK” mes-
sage (
ot
) as indicated above
3.6.3 Firmware Update
Allows the user to upgrade KONTROL 5’s internal firmware from a USB Flash
“Thumbdrive.”
WARNING: AFTER STARTING FIRMWARE UPGRADE, DO NOT POWER DOWN
KONTROL 5 UNTIL THE UPGRADE FINISHES!!! UNPLUG ALL FIXTURES FROM
KONTROL 5 PRIOR TO PROCEEDING.