Blaupunkt CASABLANCA MP56 - Manual (Page 59)

Changing basic settings in the settings menu
124
Switching the internal amplifi er
on/off ( AMP ON)
If you connected the device to an
external power amplifi er via the
preamplifi er outputs (Preamp),
you can switch off the internal
amplifi er of the device as follows:
CAUTION!
No sound with switched-
off internal amplifi er!
If you switch off the internal am-
plifi er, you do not hear a sound
from the loudspeakers connected
to the device!
Switch off the internal amplifi -
er only if you connected an ex-
ternal power amplifi er to the
preamplifi er outputs (Preamp)
of the device and you connect-
ed your loudspeakers to this
power amplifi er.
Press the softkey 8 (next to
"AMP ON").
The status of the internal am-
plifi er is shown on the main
line
A
:
"INTERNAL AMP ON": The in-
ternal amplifi er is switched
on. Loudspeakers connected
to the device play back the
selected audio source.
➔
➔
•
"INTERNAL AMP OFF": The
internal amplifi er is switched
off. Loudspeakers connected
to the device always remain
mute. The loudspeakers must
be connected to the external
amplifi er.
Resetting the device to factory
settings ( NORMSET)
Press and hold the softkey <
(next to "NORMSET") for ap-
prox. two seconds.
The main line
A
briefl y dis-
plays "NORMSET ON". The de-
vice is reset to the factory set-
tings.
Changing the scan time
( SCANTIME)
Press the softkey ; (next to
"SCANTIME").
The "SCANTIME" menu item is
fl ashing. The current scan time
is shown on the main line A .
On the rocker switch 3 ,
repeatedly press or to
increase the scan time.
On the rocker switch
3 ,
repeatedly press or to
decrease the scan time.
You can adjust scan times in
increments of 5 seconds form
5 to 30 seconds.
•
➔
➔
➔
➔
03_BA_Casablanca_1_ENG.indd Menü124 03_BA_Casablanca_1_ENG.indd Menü124 31.05.2006 11:15:58 Uhr 31.05.2006 11:15:58 Uhr