Blizzard Lighting CSI Xtreme The Puck (Rev A) - Manual (Page 13)

Page 13
The Puck CSI Xtreme User Manual Rev. A Copyright (c) 2013 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1. To set the fixture to run in 4-channel DMX mode, use the
navigate to
d001
, then press . To choose a different starting DMX
address, use the buttons to select from
d001-d512
. Then
press the button to confirm.
2. To set the fixture to run in 8-channel DMX mode, use the
navigate to
A001
, then press . To choose a different starting DMX
address, use the buttons to select from
A001-A512
. Then
press the button to confirm.
Master/Slave Mode (Auto & Sound Active Modes):
Allows you to link up to 32 units together without a controller.
1.) Use standard DMX cables to daisy chain your units together via the DMX con-
nector on the rear of the units. It may be necessary to use a terminator at the
last fixture.
2.) To set one or more fixtures to act as slave units, use the
buttons to reach
SLAV
in the menu on the slave units, then push .
These units will now react in the same as the master fixture.
3.) Then on the master fixture, use the buttons to reach:
Sound Active
SoUn
then to confirm.
Auto Mode
dEoo
then to confirm.
Fade Mode
FF --
then
FF0 1 - FF99,
.
Jump Mode
CC --
then
CC0 1 - CC99,
.
Set custom intensity levels in M/S & Standalone Modes:
Using this function, you can adjust the intensity of LED segments 1, 2, 3 and 4 by adjust-
ing their values from 0-255. You can also use this function to adjust the overall maximum
intensity of the fixture in any mode.
Please note that modifying the values in this step will affect ALL modes, therefore
we recommend resetting all levels to their highest value (255) after using this
mode.
1.) Use the
r255, G255, b255,
or
u255
then press . Then to set different intensity levels for any of these use
the buttons to select from
001-512
(0% <--> 100%). Then
press the button to confirm.