Blizzard Lighting Memerizor RGB 3D Laser(Rev A) - Manual (Page 12)

Page 12
Mezmerizor™ Manual - Rev. A (c) 2013 Blizzard Lighting, LLC
Channel Function Value Description
7
Dual
Pattern Mode
000 <-> 027
028 <-> 055
056 <-> 083
084 <-> 111
112 <-> 139
140 <-> 167
168 <-> 195
196 <-> 223
224 <-> 251
252 <-> 256
Single Pattern Mode (Channels 5 & 6 no Func)
X Phase
Y Phase
X/Y Phase Together
Zoom Phase
Pattern 1 (No Sine), Pattern 2 (Sine Wave)
Pattern 1 (No Zoom), Pattern 2 (Zoom)
Pattern 1 (No Rotation), Pattern 2 (Rotation)
Rotation Phase
Pattern 1 (Adjustable X Position), Pattern 2
(Adjustable Y Position)
8
Moving-X
000 <-> 127
128 <-> 160
161 <-> 192
193 <-> 224
225 <-> 239
240 <-> 247
248 <-> 255
Manual Left/Right Movement
Auto Left Movement
Auto Right Movement
Auto Left/Right Movement
Jumping
Rhombus Movement
Upper Corner Movement
9 Moving-Y
000 <-> 127
128 <-> 160
161 <-> 192
193 <-> 224
225 <-> 231
232 <-> 239
240 <-> 247
248 <-> 255
Manual Up/Down Movement
Auto Down Movement
Auto Up Movement
Auto Up/Down Movement
Circular Movement
Auto X Fluctuation
Auto Square Fluctuation
Lower Corner Movement
10 X-Axis Rotation
000 <-> 150
151 <-> 255
Manual Position
Auto Position Spin
11 Y-Axis Rotation
000 <-> 150
151 <-> 255
Manual Position
Auto Position Spin
12
Rotation
000 <-> 127
128 <-> 159
160 <-> 291
192 <-> 223
224 <-> 255
Manual Rotation
Auto Clockwise Rotation
Auto Counter Clockwise Rotation
Auto Clockwise/Counter Clockwise Rotation
Ellipse Tracking Rotation
13
Pattern Zoom
(+/-)
000
001 <-> 159
160 <-> 191
192 <-> 223
224 <-> 255
No Function
Manual Zoom (-/+)
Auto Zoom (+)
Auto Zoom (-)
Auto Zoom (+/-)
14
Sine Wave
Fluctuation
000 <-> 128
129 <-> 255
X Fluctuation
Y Fluctuation
15 Drawing
000 <-> 064
065 <-> 255
Manual Draw
Auto Draw (Slow <--> Fast)
Troubleshooting
Symptom Solution
Fixture Auto-Shut
Off
Check the fan in the fixture. If it is stopped or moving slower than normal,
the unit may have shut itself off due to high heat. This is to protect the fixture
from overheating. Clear the fan of obstructions, or return the unit for service.
Beam is Dim Check optical system and clean excess dust/grime. Also ensure that the
220V/110V switch is in the correct position, if applicable.