Blizzard Lighting Q Flurry(Rev C) - Manual (Page 12)

Page 12
Flurry Q Manual Rev. C Copyright (c) 2011-12 Blizzard Lighting, LLC
Additional User Adjustments
TO SET THE PAN TO REVERSED OR NORMAL:
1.) Press the
PAN
2.) Use the <+/-> buttons to set to the desired position,
press to confirm.
TO SET THE TILT TO REVERSED OR NORMAL:
1.) Press the
TILT
2.) Use the <+/-> buttons to set to the desired position,
press to confirm.
TO SET THE LED READOUT TO REVERSED OR NORMAL:
1.) Press the
dISP
2.) Use the <+/-> buttons to set to the desired position,
press to confirm.
TO SET THE DMX CHANNEL CONFIGURATION:
1.) Press the
ChNd
2.) Use the <+/-> buttons to set to the desired position,
press to confirm.
Service Functions
TO RESET THE FIXTURE:
1.) Press the
rSET
2.) Press to confirm your selection.
TO ADJUST THE FIXTURE COLOR BALANCE:
Note: This will adjust the LED intensity of the Red/Green/Blue/White LEDs for
ALL operating modes. Use with caution. Setting the color balance incorrectly
can cause colors to appear dimmer than expected
1.) Select the operating mode you will be operating in (DMX/Auto/
Sound Active/Etc.), then press to confirm your selection.
2.) Press and hold the
BALA
, then press to confirm your
selection.
3.) Use the <+/-> buttons to select the color to adjust between Red,
Green, Blue and White, then press to confirm your selec-
tion.
4.) Use the <+/-> buttons to adjust the color intensity between 0
(lowest) and 255 (highest), then press to confirm your
selection.
5.) Press and hold the
to return to the previous operating mode.
Note: The fixture’s default/factory setting is with all colors set to 255.