Blizzard Lighting Q Flurry(Rev C) - Manual (Page 11)

Page 11
Flurry Q Manual Rev. C Copyright (c) 2011-12 Blizzard Lighting, LLC
Control Panel Menu Structure
**HOLD The
Display Selection Function
Addr A001
-
A512
Sets the fixture DMX Address & Sets
the fixture to DMX Mode.
ChNd
7Ch
-
12Ch
Sets the fixture in 7 (Basic) or 12 (Ex-
tended) DMX channel mode.
SLNd
NAST
-
SL 1
-
SL
2
Sets the fixture’s profile as Master
(NAST), Slave Mode 1 (SL 1), or Slave
Mode 2 (SL 2).
SouN 0 - 100
Sets the fixture in Sound Active mode,
and sets the sound sensitivity of the
unit’s internal microphone.
AuTo No - YES Sets the fixture in Auto Run mode.
STbY No - YES
Sets the unit to enter “Standby Mode”
when not receiving DMX signal, other-
wise the unit will automatically enter
Master/Slave Mode.
PAN No - YES
Sets the pan function to normal (NO) or
inverse (YES).
TILT No - YES
Sets the tilt function to normal (NO) or
inverse (YES).
dISP dSIP Sets the display to normal or inverted.
TEST Sets the fixture in internal test mode.
hour
Displays the fixture’s total running
hours.
rSET Resets the fixture.
BALA
rEd - GrEE -
bLuE - UhIT
Adjusts the color balance of each color
between 0 (lowest) and 255 (highest)
NOTE: Color balance adjustment is accessed by holding the button
for 5 seconds while in any operating mode.