beautypg.com

Getting started, Page 3 – Blizzard Lighting BlockHead Matrix Moving Head User Manual

Page 3

background image

Page 3

BlockHead™ User Manual Rev. B

(c) 2014 Blizzard Lighting, LLC

1. GETTING STARTED

What’s In The Box?

• 1 x BlockHead™ Moving Head Fixture

• 2 x Omega 1/4 Turn Mounting Brackets

A Sweet Safety Cable & Set of Mounting Brackets

• An Ever-So-Handy Power Cord

• This Lovely User Manual

Getting It Out Of The Box

Congratulations! You have just purchased a the coolest quad-color RGBW 5x5 pixel matrix

moving head fi xture on the market with infi nite pan, infi nite tilt, and infi nite awesomeness!

So now that you’re the proud owner of a BlockHead™ (or hopefully, BlockHeads!), you

should carefully unpack the box and check the contents to ensure that all parts are present

and in good condition. If anything looks as if it has been damaged in transit, notify the

shipper immediately and keep the packing material for inspection. Again, please save the

carton and all packing materials. If a fi xture must be returned to the factory, it is important

that the fi xture be returned in the original factory box and packing.

Powering Up!

All fi xtures must be powered directly off a switched circuit and cannot be run off a

rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer

channel is used solely for a 0% to 100% switch.

AC Voltage Switch - Not all fi xtures have a voltage select switch, so please verify that the

fi xture you receive is suitable for your local power supply. See the label on the fi xture or

refer to the fi xture’s specifi cations chart for more information. A fi xture’s listed current

rating is its average current draw under normal conditions. Check the fi xture or device

carefully to make sure that if a voltage selection switch exists that it is set to the correct

line voltage you will use.

Warning! Verify that the voltage select switch on your unit matches the line

voltage applied. Damage to your fi xture may result if the line voltage applied does

not match the voltage indicated on the voltage selector switch. All fi xtures must

be connected to circuits with a suitable Ground (Earthing).

Getting A Hold Of Us

If something is wrong, just give us a call or send an email. We’ll be happy to

help, honest.

Blizzard Lighting

N16 W23390 Stoneridge Dr. Ste E

Waukesha, WI 53118 USA

www.blizzardlighting.com

414-395-8365

Email: [email protected]

Disclaimer: The information and specifi cations contained in this document are subject

to change without notice. Blizzard Lighting™ assumes no responsibility or liability for any

errors or omissions that may appear in this user manual. Blizzard Lighting™ reserves the

right to update the existing document or to create a new document to correct any errors

or omissions at any time. You can download the latest version of this document from www.

blizzardlighting.com.

Author:

Date:

Last Edited:

Date:

J. Thomas

6/26/2014

J. Henry

11/5/2014