Page 13 – Blizzard Lighting BladeRunner White(Rev A) User Manual

Page 13

Page 13

BladeRunner™ White User Manual Rev. A

Manual Color Adjustments

Allows the user to adjust the intensity level of each individual moving head fixture. You can set your own
intensity levels and then add PRO-Movement if you like! (See p. 12).

1.) Use the

button to scroll to COLOR, then use the buttons to
display the White intensity levels for fixtures 1, 2, 3, and 4. Push the button while
highlighting any to display the color intensity range settings from 000-255. Use the DOWN> buttons to adjust the intensity, then push to confirm your choice.

2.) The last option in the COLOR submenu is Shut (strobe). Using the same steps as above,
you can adjust the strobe rate values from 000-255 (slow <--> fast).

Program Mode

Allows a single unit to display a variety of built-in programs without a DMX controller.

1.) Use the

button to scroll to PROGRAM, then use the buttons to
display the built-in program number from 01-10. Push the to confirm your choice. If
you wish, you can then also enable/disable PRO-Movement, or adjust the Speed Settings of the
Movement or Color Macros. (See p. 12)

LCD Display

To turn on/off the backlit LCD display, use the

button to scroll to LED, then push
. Then use the buttons to scroll or either ON or OFF, and push
button to confirm your choice. ON will leave the display illuminated constantly, and
OFF will turn the display off after 40 seconds of idle.

Version

This menu option simply displays the fixtures installed firmware version number.

Reset

To automatically reset the motors to realign the moving head positions, use the

button to scroll to RESET, then push .