Bennett Marine NMEA 2000 Indicator Kit User Manual
Page 2
Wiring NMEA1 to NMEA2000 Backbone
1. Using red butt connectors,
splice the red and green wires
from sensors to the red and
green wires from the NMEA1
module. Note either red and
green wires from the sensor
may be spliced to either red or
green wire from the NMEA1
module.
2. Run the connection cable from
the NMEA1 Module to the
Backbone cable of your NMEA2000 system.
3. Connect the cable into the Backbone
using a red Device Net “T” (not included).
You will need to purchase this “T” or
buy an adapter to fit your current
NMEA2000 system. Please contact
your electronics manufacturer.
4. Make sure the Backbone system
has the correct terminator in place.
5. Your NMEA1 Trim Tab position
sensor is now installed. Refer
to the Lowrance, or other
electronics manufacturer’s
instructions for calibration of
the system.
Bennett Marine
550 Jim Moran Blvd. Deerfield Beach, FL 33442 USA
Phone 954-427-1400 Fax 954-480-2897
Web Site
E-mail [email protected]