Bendix Commercial Vehicle Systems DOUBLE ANCHOR PIN CAM BRAKE 5/04 - Manual (Page 4)

4
FIGURE 5 - REMOVING SHOES
FIGURE 4 - REMOVING SHOE RETURN SPRING
FIGURE 7 - REMOVING ACTUATOR BRACKET
FIGURE 6 - REMOVING SLACK ADJUSTER
PREPARATION
1. Park vehicle on a level surface and prevent movement
by means other than the brakes.
2. If equipped with spring brakes, cage the spring on all
axles to be worked on.
3. Drain air from all reservoirs.
4. Raise the axle, to be worked on until the tires clear the
ground.
5. Turn the slack adjuster adjusting screw in the opposite
direction used to adjust the brakes until the cam rollers
return to the start position on the S-cam.
6. Remove wheels and drums using the procedures specified
in the vehicle maintenance manual.
FIGURE 3 - REMOVING CAM ROLLERS