beautypg.com

Baumfolder 714XLT: Sound Cvr Manual User Manual

Page 9

background image

9 TP10330

Figure 3

8. Mount the swivle base to the outside of the side guard

using the four screws provided(Figure 4).

Warning: Make certain that the swivel base is below the

radius of the curve of the side guard or beakage of the

guard could take place.

min=0.125"

max=0.250"

max=0.250"

9. Remove the thumb screw on the top section of the

mounting post and insert the mounting post on the bottom of

the counter fully into the hole. Reinstall and tighten the thumb

screw in the top section of the mounting post(Figure 5).

10. Adjust the counter for a comfortable viewing angle and

tighten all thumb screws and jam nuts.

Figure 4

11. Reconnect the air and vacuum hoses to the manifold

block on the side of the folder frame. Double check to make

sure that the hoses have been reconnected correctly.

Replace the guard to the right side of the folder and secure the

cover screws.

12. Reinstall the infeed table and re-attach the air and

vacuum hoses to the manifold block.

13. Connect the scanner connector (white nylon) to the

matting connector on the counter then connect the solenoid

assembly connector to the circular connector on the counter.

See Figure 6 for placement of the scan sensor.

14. Connect (plug in) the folder and the counter to a well

grounded 115 VAC outlet.

15. Turn on the counter with the switch located in the rear

of the unit. NOTE: The solenoid will energize for a short

period each time the counter is turned on. Reset the counter

(see reset instructions). Thank you, and enjoy the convenience

and increased productivity your DCU-600 batch counter will

provide.

Figure 5