beautypg.com

Metric cap screws, Kit installation – Baumfolder 714XLT: Sound Cvr Manual User Manual

Page 8

background image

TP10330

8

KIT INSTALLATION

CAUTION: BE SURE THE FOLDER IS TURNED OFF

AND UNPLUGGED FROM THE AC POWER BEFORE

REMOVING ANY GUARDS AND STARTING THE IN-

STALLATION.

WARNING: IT IS RECOMMENDED THAT YOU HAVE

A QUALIFIED SERVICE PERSON PERFORM THE FOL-

LOWING PROCEDURE BECAUSE OF THE DANGER

FROM HAZARDOUS MOVING PARTS, ELECTRICAL

SHOCK (SEE CAUTION ABOVE) AND DAMAGE TO

THE FOLDER. HOWEVER IF YOU WISH TO PRO-

CEED ON YOUR OWN, USE EXTREME CARE.

BAUMFOLDER CORPORATION ASSUMES NO RE-

SPONSIBILITY FOR DAMAGE CAUSED TO YOUR

FOLDER OR PERSONAL INJURY.

1. Remove the infeed table air and vacuum hoses from

the manifold block on the right side of the folder frame. Note

the orientation of the hoses for re-installing.

2. Remove the infeed table and carefully lay it upside

down on a stable flat surface.

3. Apply a strip of Teflon tape to the threads of the

plastic elbow adapters. Screw them into each side of the

solenoid valve so that the barbed end are out towards the

electric junction box. Remove the two top bolts(when IN is

to your left) and attach the monuting bracket.(Figure 1)

4. Carefully remove the two metric socket head cap

screws and mount the vacuum solenoid assembly.(Figure 2)

Re-insert and tighten the two metric socket head cap screws.

Figure 1

5. Remove the vacuum hose from the adapter on the

vacuum feed wheel assembly and replace with the shorter of

the new hoses. The loose end of the new hose is to be

attached to the adapter on the “IN” side of the vacuum

solenoid. Attach the other new hose to the “OUT” side of the

vacuum solenoid, add the manifold adapter from the old hose

to the loose end.

6. Remove the four screws that attach the right side cover

to the frame. Carefully remove the right side cover. You will

notice that the air and vacuum hoses inside the cover will need

to be removed from the manifold block. Observe which hose

goes to which adapter on the block, and remove them.

7. Lay the right side cover on a protected flat surface so

that you do not scratch or mar the plastic surface. You are

now going to use the mounting block to locate the

holes(Figure 3) that you will need to drill for mounting the

counter support assembly. After marking the holes, remove

the backing plate and drill your four holes using a 0.217 drill

bit.

METRIC CAP SCREWS

Figure 2