Baumfolder 714XLT: Batch Ctr Manual User Manual
Page 4

T P 1 0 3 0 2 A
PAGE 4
5) Remove the the operator handwheel using an allen
wrench to loosen the set screw. Set the handwheel
aside for re-installation.
6) Using an allen wrench, remove the operators side
guard by removing the four button head screws that
attach the guard to the frame.
The guard on the operators side contains the folder
drive motor and counter wires which should be marked
if they are going to be removed.
Use care when installing the operator side guard so as
not to pinch or damage any of the wires.
7) Using Items 2, 3, 4 & 8 of Figure 3, attach Item 9 to
both sides of Item 1. Do Not tighten at this time as the
cover will need to be aligned and centered with the
folder frame.
8) Attach the assembled cover to the frame with Items
5, 6, 7 & 10 of Figure 3.
Align and center the cover with the folder frame.
Securely tighten the hinge to cover hardware of step 7.
9) As in Figure 4, attach Item 4 to the non operator
folder frame using Items 2, 3 & 5.
10) Repeat 9) above to attach Item 4 to the top cover
Item 1.(Figure 4)
11) If removed re-attach the folder drive motor and
counter wires. Re-install the operator side guard and
re-attach the operator handwheel.
12) Re-install the non operator side guard.
Fasten the hinge mounting brackets to the folder
frame.(Figure 5, Item 1)
13) The next step is to install the top part of the hinge
to the sound cover door with the pin pointing down.
The top of the door has the finger hole for opening the
door.
14) Mount the the latching bracket to the operators
side frame. Attach the magnet to the latching bracket.
Close the rear sound cover door to check alignment,
adjust the bracket until the door is latched.
1
Figure 5
15) Your sound cover guard installation is now
complete.