Baumfolder BAUM20: Ifold Operation Manual - Manual (Page 11)

These are
as show the number of sheets th
at go u
nder
each g
apset and the fold plate s
ettings for ev
ery
station required to do the selected fold. The black
boxes indicate the gapset and fold plate num
bers,
the dark blue boxes indicate the number of sheets th
at go under the corresponding gapset and the light
blue or gray boxes indicate the fo
ld plate setting. Exam
ple: On the
parallel station gapset num
ber 1
needs 1 sheet of paper and fold plate num
ber 1 is
set to 8 ½ inches to do
the selected fold. Touch
anywhere in
each area and it will tak
e you to the
correspond
ing adjustm
ent screen, from
that screen
you can m
ake any changes needed to the num
ber of sh
eets in the gapsets or the fold plate settings.
This area sh
ows the current
fold selected and if it
is saved what nam
e it is saved under. Touch the
blue box under the
fold saved name
to go to the
save job
screen.
Touch this button to see the setup list. The setup
list is explained on page 4.
This area shows the suggested scoring dies for each
station to ru
n the selected
fold.
This area sh
ows the feeder setting
s.
Where to set the non-operator side paper guide and the blow tube settings.
TP10509 Page 9 of 29