Bang & Olufsen BeoLine 2 - User Guide - Manual (Page 52)

English
This equipment complies with Part 68 of the
Federal Communications Commission (FCC)
rules for the United States.
A label is located on the base unit containing
either the FCC registration number and
Ringer Equivalence Number (REN). You must
upon request, provide the following
information to your local telephone company:
USOC Jack Type: RJ11
REN: 0.1B
The REN is used to determine the quantity of
devices which may be connected to the
telephone line. Excessive RENs on the
telephone line may result in the devices not
ringing in response to an incoming call. In
most, but not all areas, the sum of RENs should
not exceed five (5.0). To be certain of the
number of devices that may be connected
to a line, as determined by the total RENs,
contact the local telephone company.
If the equipment is causing harm to the
telephone network, the telephone company
may request that you disconnect the
equipment until the problem is resolved.
This equipment cannot be used on public
coin phone service provided by the
telephone company. Connection to party
line service is subject to state tariffs.
Radio frequency radiation exposure
information:
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be
installed and operated with minimum
distance of 20 cm between the radiator and
your body. This transmitter must not be
co-located or operating in conjunction with
any other antenna or transmitter.
Your telephone company may discontinue
your service if your equip ment causes harm
to the tele phone network. They will notify
you in advance of disconnection, if possible.
During notification, you will be informed of
your right to file a complaint to the FCC.
Occasionally, your telephone company may
make changes in its faci lities, equipment,
operation, or procedures that could affect
the operation of your equipment. If so, you
will be given advance notice of the change
to give you an opportu nity to maintain
uninterrupted service.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s authority
to operate the equipment.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in
a particular installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or
more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the
equipment and receiver.
– Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced
radio/TV technician for help.
For the American market only …
52