Bang & Olufsen BeoCenter 2 Socket Unit - User Guide - Manual (Page 4)

Placing your music system
Make sure that the music system is
set up, placed and connected in
accordance with the instructions in
this guide.
We recommend that you follow this
procedure when you set up your
music system:
1 Connect the cable between the
Master unit and the Socket unit
2 Connect all cables to the sockets in
the Socket unit – remember not to
connect it to the mains yet
3 Lead the cables through the
opening at each end of the Socket
unit
4 Mount the cover for the sockets on
the Socket unit
5 Connect the products to the mains
If you wish to mount the Socket unit
on a wall bracket, refer to the
following pages.
– Place your music system on a firm surface,
preferably on the table, sideboard or stand
where you want it placed permanently. Use
Bang & Olufsen approved stands and wall
brackets only!
– Do not place any items on top of
BeoCenter 2.
– The music system is designed for indoor use
in dry, domestic environments only, and for
use within a temperature range of
10–40º C (50–105º F).
– Avoid placing the system in direct sunlight,
near radiators or other sources of heat.
– Do not connect any of the products in your
system to the mains, until you have
connected all the cables (refer to page 6).
– The music system can only be switched off
completely by disconnecting it from the
mains supply. Therefore, connect the music
system to an easily accessible wall socket.
– If the Socket unit is placed close to the floor,
it is best to connect all the necessary cables
to the Socket unit before you mount it on
the wall bracket. Also make sure that there
is room enough to detach the Socket unit
from the wall bracket again.
– Before mounting the wall bracket, ensure
that all cables have the proper length.
– The Socket unit can be placed vertically or
horisontally, for example on the floor – how-
ever, the need for ventilation must be
observed. If required, the Socket unit can
be fastened to the wall with the enclosed
wall bracket (refer to page 8).
Remember to leave enough space at the sides for
the doors to open.
To ensure proper ventilation, allow for at least 5 cm
(2") of space at the sides of the Socket unit and
10 cm (4") above the unit. The Socket unit must
under no circumstances be covered by for example
insulation material.
Placing the Master unit and the Socket unit …
4