BT Studio 3500 User Manual
Page 31
Record your own OGM
This will replace the pre-recorded or your own previous
outgoing message. However, you can re-instate the
pre-recorded OGM at any time by deleting your own
recorded OGM.
Using the base:
1. Press and hold
until prompted to select which type of
OGM you want to record.
2. Press and keep holding
to select Answer & Record
or
to select Answer Only. The machine announces
“Please speak after the tone to end recording release the
button”, then a beep is heard.
3. Whilst still holding
or
, speak your message slowly
and clearly, close to the base.
4. To end recording, release the
or
button.
Using the handset:
1. Press ,
scroll to
TAM SETTINGS
and press
.
2. Scroll to
OGM SETTING
and press
.
3. Scroll to
RECORD OGM
and press
.
4. Press
or
to select either ANS AND REC or ANS ONLY and
press
.
31
Using the answering machine
BT Studio 3500 – Issue 1 – Edition 2.1 –02.04.07 – 7999
If you experience any problems, please call the Helpline on 0870 605 8047 or email [email protected]
Answer Only
With Answer Only selected, your
caller will hear an announcement only
and will not be able to leave
a message. The pre-set Answer Only
outgoing message is “Hello, your call
cannot be taken at the moment and
you cannot leave a message, so
please call later”.
If recording your own Answer Only
message, remember to advise your
caller that they will not be able to
leave a message.
To reinstate either pre-recorded
message, delete your own message.
8474 Studio 3500 UG Iss2 [2] 25/10/07 16:37 Page 31