Bang & Olufsen BeoLab 5 - User Guide - Manual (Page 7)

The illustration to the left shows the placement
of different parts:
1 Touch field
2 Indicator light
3 High frequency speaker dome – do not touch!
4 Mid frequency speaker dome – do not touch!
5 Receiver for Beo4 remote control signals
6 Upper bass speaker unit
7 Moving microphone for the Adaptive Bass
Control system
8 Lower bass speaker unit
9 Cover for socket panel
10 Base
11 Beo4 remote control (optional accessory)
12 Product label
Cover for socket panel: To get access to the sockets
and the RIGHT–LEFT switch, you will have to remove
the cover. To do so, pull out the bottom edge of the
cover, as illustrated above
Cable cover: Place the mains lead and the signal
cables inside the enclosed cable cover, and then
use the special tool to seal the cover.
Cable clamp: For safety reasons the mains lead
must be secured to the loudspeaker. To do so,
place the cable cover with the cables behind the
clamp, and tighten the two screws.
2
3
4
5
7
9
12
10
11
8
6
1
7