Bang & Olufsen BeoLab 3 - User Guide - Manual (Page 3)

Daily use
When you have finished setting up the loudspeakers as described on
the following pages, connect the entire system to the mains. The
loudspeakers are designed to be left in standby when not in use.
Switching on and off
When you switch on your system,
the loudspeaker switches on simul­
taneously, and the indicator light
shines green.
When you switch off your system,
or mute the sound, the indicator
light turns red.
Cleaning
Clean the loudspeaker surfaces
using a soft, lint­free cloth which
you have dipped in lukewarm
water and wrung firmly.
Never use alcohol or other solvents to
clean any parts of the loudspeaker!
Loudspeaker protection
The loudspeaker is equipped with a
thermal protection system which
prevents overheating. If an error
occurs – or the speaker units
become overheated – the system
automatically switches the
loudspeaker to standby, and the
indicator light turns yellow.
To restore the situation:
> Disconnect the loudspeaker from
the mains.
> Allow the system time to reset
(approximately 3–5 minutes).
> Reconnect the loudspeaker to
the mains again.
Should the problem persist, contact
your Bang & Olufsen retailer.
!
3
Indicator light: In daily use the
indicator light shines either red
(standby) or greAen (playing). If an
error occurs – or the speaker units
become overheated – the light
switches to yellow.
Caution: Do not touch the BeoLab 3
top speaker membrane!