Bang & Olufsen BeoLab 2 - User Guide - Manual (Page 4)

4
We recommend that you follow
this procedure when setting up
the BeoLab 2 subwoofer:
– Read and abide by the cautions
on these two pages.
– Disconnect your system from
the mains.
– Connect your speaker system as
described in Connect your
speaker system.
– Set the SETUP switch and the
POSITION switch to the correct
settings as described in Adapt
BeoLab 2 to your setup.
– Place BeoLab 2 according to the
guidelines in Adapt BeoLab 2 to
your setup.
– Finally, connect your system to
the mains.
To make a neat cable installation,
we suggest that you run the
cables through the enclosed cable
cover.
Before you start…
Cautions
■ The BeoLab 2 subwoofer is intended for
use with Bang & Olufsen active (Power
Link) loudspeaker systems only – it cannot
be used with other speakers.
■ Make sure that the BeoLab 2 is placed
and connected in accordance with the
instructions in this Guide.
■ Do not in any way block the free
movement of the BeoLab 2 speaker units,
and do not apply any force to them, as this
may result in permanent damage!
■ Place your BeoLab 2 on the floor on its
black rubber foot.
■ The BeoLab 2 is designed for indoor use
in dry, domestic environments only, and for
use within a temperature range of 10–40º C
(50–105º F).
■ Remember that all speakers in a setup
must be connected to a mains outlet, and
that they are designed to be connected to
the mains at all times, as this allows them
to switch on automatically.
Leave enough space for the speaker units to
move – both in front and to the sides of
BeoLab 2.
Use the top hole as a carrying ’handle’ when
you lift BeoLab 2.
Take care not to damage the speaker units,
and never lift BeoLab 2 by gripping its sides!
A
B
Bottom view of BeoLab 2 showing the
location of the product identification label (A).
If you wish to adjust the black rubber foot,
place BeoLab 2 upside down and use the two
adjustment screws (B).