Bang & Olufsen DVD 1 - User Guide - Manual (Page 8)

8
In this chapter you will find instructions
explaining how to gain access to
DVD 1 functions via the close-up
operation panel on the front of
DVD 1 and via the Beo4 remote
control.
Your key to using DVD 1
Load a DVD or CD and start
playback
To load a DVD or CD for playback, press EJECT
on the close-up operation panel. To start
playback, press PLAY.
To load a disc…
> Press EJECT on the close-up operation panel.
The loader slides out.
> Place a disc in the loader. DVD, video CD and
audio CD are valid disc types.
> Press the DVD button on Beo4 or PLAY on the
close-up operation panel to close the loader
and start playback.
You can load a disc for playback at a later time.
Press EJECT from stand-by mode, place a disc in
the loader, and press EJECT again. DVD 1 will
remain in stand-by mode.
Use the close-up operation panel
The close-up operation panel allows you to
load and unload discs, to start, pause or stop
playback, to cue forward or backward on a
disc or to view the elapsed playing time.
The close-up operation panel
EJECT
Press to open or close the loader.
ss tt
Press to cue forward or backward during playback.
PLAY
Press to start playback. Press again to pause
playback at the current still picture or audio track.
STAND-BY
Press to switch DVD 1 to stand-by mode. Stops
playback without switching to stand-by if pressed
during playback or pause mode.
DISPLAY
The display to the right shows the elapsed playing
time of a DVD or the current track number being
played on an audio CD. Switching DVD chapters
causes the appropriate chapter number to be
shown in the display for a few seconds.
EJECT PLAY