Bushnell 53-0021 User Manual

Page 7

WARRANTY / REPAIR

TWO-YEAR LIMITED WARRANTY
Your Bushnell® product is warranted to be free of defects in materials and workmanship for two years after the date of purchase. In
the event of a defect under this warranty, we will, at our option, repair or replace the product, provided that you return the product
postage prepaid. This warranty does not cover damages caused by misuse, improper handling, installation, or maintenance provided by
someone other than a Bushnell Authorized Service Department.
Any return made under this warranty must be accompanied by the items listed below:
1) A check/money order in the amount of $15.00 (USD) to cover the cost of postage and handling
2) Name and address for product return
3) An explanation of the defect
4) Proof of Date Purchased
5) Product should be well packed in a sturdy outside shipping carton, to prevent damage in transit, with return postage prepaid to
the address listed below:
IN U.S.A. Send To:

IN CANADA Send To:

Bushnell Performance Optics

Attn.: Repairs

8500 Marshall Drive

25A East Pearce Street, Unit 1

Lenexa, Kansas 66214

Richmond Hill, Ontario L4B 2M9

For products purchased outside the United States or Canada please contact your local dealer for applicable warranty information. In
Europe you may also contact Bushnell at:

BUSHNELL Performance Optics

Gmbh European Service Centre

MORSESTRASSE 4

D- 50769 KÖLN

GERMANY

Tél: +49 (0) 221 709 939 3

Fax: +49 (0) 221 709 939 8

This warranty gives you speciﬁc legal rights. You may have other rights which vary from country to country.

MAINTENANCE AND CARE

1. The holographic image glass is coated with anti-reﬂection material. When cleaning the glass surfaces,

ﬁrst remove any dirt and dust with compressed air or by blowing on the glass surfaces. Fingerprints or

lubricants can be wiped off with lens tissue or a soft cotton cloth, moistened with lens cleaning ﬂuid

or glass cleaner.

Never clean the glass surface with a dry cloth or paper towel; always dampen the glass

surfaces prior to cleaning.

2. All moving parts of the sight are permanently lubricated. Do not try to lubricate them.

3. No maintenance is needed on the sight’s surface, except to occasionally wipe off with a soft cloth. Use

only a water-based cleaner such as glass cleaner, ammonia, or soap and water. Never use any solvent-

type cleaner such as alcohol or acetone.

4. Never disassemble the sight. The optical cavity is nitrogen ﬁlled and sealed. Disassembly will void the warranty.

LASER SAFETY

The Bushnell® Holosight® XLP is a Class II laser product. The laser’s illuminating beam, however, is

contained within the housing. The only laser light accessible to the eye is at a power level within the limit

of a Class IIa laser product. The laser’s illuminating beam can become accessible to the eye if the housing

is broken. Turn the sight off immediately and discontinue use until repaired.