AJA D5CE - Manual (Page 5)

1
5 AJA D5CE Serial Digital Encoder User Manual — User Controls
User Controls
The user interface for the D5CE is a 4-switch DIP
accessible through a cut-out in the bottom of the
unit. Use the DIP switches to configure outputs,
pedestal, blanking, and choose type of component
output (if using component).
Switches 1 and 2 select output BNC video format.
Switches 3 and 4 configure pedestal and blanking.
The exact function of each DIP switch and what it
controls is described on the following pages.
Switch 1—Selects Composite or Component Video Output (3 BNCs)
:
Switch 2—Select Video Format of Outputs (3 BNCs)
:
Switch 3—Configure Pedestal
:
Note: There is no effect with 625 input.
ON OFF
COMPNT:
Selects component video output CMPSTE:
Selects composite video output and Y/C output
ON OFF
YPbPr/YC:
If SW1 is set to COMPNT, this selection
outputs
Y, R-Y, B-Y
If SW 1 is set to CMPSTE, this selection
outputs 1 composite and 1 Y/C RGB:
If SW1 is set to COMPNT, this selection outputs
RGB
If SW1 is set to CMPSTE, this selection outputs 3
composites
ON OFF, RGB
7.5 IRE pedestal for NTSC (also selects
BETA 525 levels for YUV) No pedestal (also selects SMPTE levels for YUV)
DIP Switches
1
2
3
4
5
6
7
8
8
OFF ON