Belkin P74279ea - Manual (Page 7)

7
En
Hardware Installation
2.1 Hardware Installation
Your mouse connects to either a PS/2 mouse port or a Universal Serial Bus
(USB) port . To check, look at the back of your computer for the port that is
designated for your mouse. Some PCs will have the word MOUSE marked next to
the PS/2 connector. If you are still unsure, please refer to your hardware manual. For
USB mouse port installation, simply remove the PS/2-USB adapter from the end of
the connector before plugging the mouse into the computer.
PS/2 Installation
a. Make sure that the computer is turned off.
b. Locate the PS/2 mouse port on the back of your computer.
c. Plug your mouse into the appropriate port suggested above. Check the box in
which your mouse was shipped to verify the ports supported.
d. Turn your computer on. At this point, your mouse will work with the built-in
Microsoft ® Operating System.
Note: To use the extra features of your middle button, you must install the included
software.
P74279ea-F8E841eaBLK 24-03-2003 14:11 Page 7