Saw operations, 66 crown molding laying flat on table, Warning – Bosch 3912 User Manual
Page 66: 9 ° bevel sliding fence 31.6 ° miter crown molding, Workpiece clamp, Fig. 33
66
Crown Molding Laying Flat on Table
Follow these instructions for cutting crown molding:
1.
Move sliding fence to proper position (see Sliding Fence
on page 54).
2.
Set the bevel and miter angles using Chart 1 below.
Tighten the miter lock knob and the bevel lock handle
(Figure 33).
3.
Position molding on saw table. Use the chart below for
correct position. Clamp workpiece in place using the
workpiece clamp.
Use clamping position that does not
interfere with operation. Before switching
on, lower head assembly to make sure clamp clears guard
and head assembly.
4.
Activate the switch. Lower the head assembly and make
your cut.
5.
Wait until blade comes to a complete stop before
returning head assembly to the raised position and/or
removing workpiece.
6.
ALWAYS TAKE A TEST CUT USING SCRAP TO
CONFIRM CORRECT ANGLES.
Saw Operations
33.9
° Bevel
Sliding
Fence
31.6
° Miter
Crown Molding
45
°
30°
15°
0°
50
45
40
35
30
25
20
15
10
0
5
50
45
30
15
10
5
Workpiece Clamp
Chart 1: Crown Molding Flat on Table
FIG. 33
WARNING
!