Bosch 3912 - Manual (Page 54)

54
Basic Saw Operations
Detent Override
To Engage:
1. Lift the miter detent trigger 1 (Figure 27).
2. Push the detent override clip 2 forward and latch in place
over edge. Release miter detent trigger 1.
3. Move miter arm 3 to any position on the miter scale.
4. Lock the miter lock knob 4 to retain miter position.
To Disengage:
5. Loosen miter lock knob 4 and lift the miter detent trigger
1 to release the detent override clip 2.
Sliding Base/Fence Extension
Extend and use sliding base/fence when
making severe bevel, severe miter or
compound cuts to provide sufficient (minimum 6”) spacing
from hand to saw blade.
Sliding Base:
1. Remove hex wrench from storage position on left rear
leg.
2. Loosen two (2) socket cap screws 5 in sliding base
channel (Figure 28).
3. Extend sliding base/fence 6 to the desired position.
4. Tighten screws. Store hex wrench.
Sliding Fence:
1. Unlock the fence locking lever 7 (Figure 29).
2. Slide fence to proper position 8.
3. Relock fence in place.
During transportation, sliding base and
fence should always be secured in the full
in position.
5
10
15
50
45
40
35
30 25
FIG. 27
FIG. 28
1
2
4
3
5
6
FIG. 29 7
8
WARNING !
CAUTION !