Boulder Amplifiers Integrated Amplifier 865 - Manual (Page 35)

POWER UP VIA BOULDERLINK
With each component connected together with a Boulderlink cable,
and individually connected to the AC mains, pressing the 865’s STANDBY
pushbutton will initiate the turn-on sequence of all components.
The first time a “MASTER” 865 is powered up, it will search for any
“slave” units connected to it. As the Master finds each slave, the slave’s
ID number will be shown on the display.
If any of the connected slaves are amplifiers, then each time the
master is turned on it will display “WAITING FOR AMPS.” Each
amplifier will be turned on in the order of their Boulderlink ID. To
minimize turn on time, the amplifier’s Boulderlink IDs should be set to
the lowest sequential numbers possible other than 0. For example, use 1,
2, and 3 instead of 13, 14, and 15. An amplifier set to ID 15 will take 47
seconds to turn on.
BOULDER
LINK
5-4