Boulder Amplifiers Integrated Amplifier 865 - Manual (Page 21)

DISPLAY
The display brightness may be set to any of four brightness levels. To
change the brightness level, press the DISPLAY pushbutton. “DISPLAY
100%” will show in the display. Rotate the center control until the
desired brightness is obtained such as “DISPLAY 50%.” The number in
the display is the relative brightness.
After several seconds of not changing the brightness level, the
display will return to the “VOLUME...” indication. You may also return
to controlling volume by again pressing the DISPLAY pushbutton.
With the display at a brightness less than that of 100%, any operation
of a pushbutton or the volume control will cause the display to go to
full brightness for several seconds, and then return to the programmed
brightness. This ensures that if a function is changed, it will be noticed
whether intentional or inadvertent.
OPERATION
2-6