Buffalo Technology WLI-TX4-AG300N - Manual (Page 22)

22
Initialization
Initializing the Ethernet Converter returns it to default settings. This might be useful
if you cannot access configuration settings, have lost the password to the Ethernet
Converter, or desire to return the settings to the default factory settings.
To initialize the device, use a toothpick or straightened-out paperclicp to hold in the
recessed Reset button on the side of the Ethernet Converter until the power LED blinks
red (about 5 seconds). Allow a minute for the initialization to complete. Afterwards, you
will need to re-enter your network's SSID and encryption information to reconnect the
Ethernet Converter to your wireless network.
Reset button