3D Robotics Quad Ready-to-Fly 2013 - Manual (Page 2)

Attach propellers
2
Remove the rings from the propeller
packages. Select the ring with the
smaller internal diameter, and insert
it into the back of the propeller hub.
Remove the nuts and washers from
the motors. Add SFP propellers to the
front-left and back-right motors and SF
propellers to the front-right and back-left
motors with the writing facing towards
the sky. Make sure the writing on the
propellers faces the sky!
Charge battery
3
Place the washer over the propeller, and
secure the nut tightly on top. Always ensure
that the propellers are fastened tightly to
the motors before flying.
+
–
LiPo 3A
Connect the charger to the power
adapter cable and a wall outlet.
Connect the red cable to the + port
and the black cable to the - port.
Set the charger to LiPo and 3A.
red
black
SF
SFP
SFP
SF