WORX WU743 230mm 2000W Angle Grinder 240V - Manual (Page 14)

14
OPERATINg INSTRUCTIONS
Clamp the workpiece if it does not remain stationary due to its own
weight.
Do not strain the machine so heavily that it comes to a standstill.
Grinding and cutting discs become very hot while working; do not
touch until they have cooled.
Pull the plug from the socket-outlet when not using the
machine. With the plug inserted and mains voltage existing, the
power tool still has low power consumption even when it switched
off.
HAND gRIP AREAS
Always hold your angle grinder firmly with both hands when
operating (See Fig. E).
ROUgH gRINDINg
The best roughing results are achieved when setting the machine
at an angle of 30° to 40°. Move the machine back and forth with
moderate pressure. In this manner, the workpiece will not become
too hot, does not discolour and no grooves are formed.
Warning! Never use a cutting disc for roughing.
CUTTINg
Warning! For cutting metal, always work with the wheel
guard for cutting.
When cutting, do not press, tilt or oscillate the machine. Work with
moderate feed, adapted to the material being cut.
Do not reduce the speed of running down cutting discs by applying
sideward pressure.
The direction in which the cutting is performed is important.
•
•
•
•
1
2
3
E